JL Audio XD6001/1V2 600 Watt Mono Subwoofer Amplifier

Overview

XDv2 Series
The JL Audio XDv2 amplifiers feature big audio performance from a small footprint. With advanced NexD switching technologies, the XDv2 amps exceed 80% efficiency, running cooler than most other amplifiers. The Advanced Thermal Rollback System gives you increased reliability and better audio performance by virtually eliminating thermal shut-down. Because the XDv2 amps employ smaller cast alloy heat sinks, they can be installed in smaller spaces. XDv2 amplifiers feature a black powder-coat finish with a brushed aluminum cover for the controls.

Monoblock Class-D Subwoofer Amplifier
The XD600/1v2 is a Class-D monoblock amplifier, designed specifically for driving subwoofers. It has two positive and two negative speaker output connections to make it easier to connect multiple subwoofers. The terminals are wired in parallel internally. The amplifier is stable down to 2 ohms.

Amplifier Rating
The XD600/1v2 is rated at 400 Watts RMS x 1 channel at 4-ohms (20 Hz to 20 kHz), Signal-to-Noise Ratio of >87 dB, 1% THD, @14.4 Volts. At 3 ohms, the rated power is 500 Watts RMS, and at 2 ohms, it outputs 600 Watts RMS.

Advanced Rollback Protection
The XDv2-Series amplifiers employ advanced thermal and low-impedance protection to virtually eliminate annoying amplifier shut-down events. Should any XDv2-Series amplifier ever overheat, its intelligent, unregulated power supply reacts by limiting available peak voltage until the amplifier returns to a safe temperature range. Likewise, if an impedance lower than optimal for the amplifier is present at the outputs, the XDv2 amplifier will roll back peak voltage to protect itself without shutting down.

Differential-Balanced Inputs
The XD600/1v2 features differential-balanced input architecture to effectively control noise and ensure compatibility with a wide variety of source units, including many OEM systems. Without resorting to line output converters, you can directly connect most OEM source units to the amplifier without creating any noise or compatibility issues. Unlike conventional single-ended inputs, the differential-balanced design does not connect one side of the audio signal to chassis ground. This eliminates any voltage sensitivity between one input terminal and ground and greatly reduces the incidence of alternator whine in a typical car audio installation.

Key Features

Mono subwoofer amplifer

400 watts RMS x 1 at 4 ohms (600 watts RMS x 1 at 2 ohms)

Variable low-pass filter (50-500 Hz, 12 or 24 dB/octave)

Switchable subsonic filter (30 Hz, 24 dB/oct)

Optional wired remote level controller

Class D amplifier design with NextD switching amp technology

differential-balanced inputs eliminate noise coming from your vehicle's electrical system

Advanced Rollback Protection System prevents thermal shut-down